Hid bi xenon installation guide

You have purchased a Kensun HID conversion kit. Remove the existing halogen bulbs from the vehicle refer to your vehicle's owner's manual for instructions.

Some vehicles require more work than others due to their unique bulb housings and may necessitate the headlight housing and bumper to be removed entirely during installation. Drill a 1 inch hole in the dust cap and use the rubber grommet supplied with a single beam kit to seal the hole or replace it with something of the same size to ensure a good closure. The bulb should sit where the original bulb was located and the bulb connector should be connected to the bulb.

The relay should be connected to the original bulb plug. Seal the headlight housing with the dust cap. Assemble the brackets unto the ballasts and mount the ballasts unto a solid and well-ventilated location under the hood near the headlight reflector. Allow the necessary distance for the base connector to reach the bulb. Connect all the plugs from the ballast to the bulb as shown in the diagrams. Ensure that you get the polarity correct.

HID lights do not work with reversed polarity. Make sure that the plugs are securely placed and firmly intact. If you have a bi-xenon kit, connect the ballasts to the relay harness. You must have JavaScript enabled in your browser to utilize the functionality of this website.

The other factory connector will NOT be connected to anything. My Account Email Password Login. Register Free! My Cart 0. Shop by Bulb Size. Shop by Ballast. Shop by Color. Shop by Car.

T10 LED Bulbs. HID Spare Ballasts. HID Accessories. Connect the round connector from the Ballasts to the Ballast Adapters. Secure the positive and negative wires to your Battery terminals.